Dial Plan (digits) for Voxalot - CYT Devices

[doctorh]

I have a VTech 8100-2, and plan to use it with Voxalot.

What should be the dial plan (digits) in order to pass everything that is dialed to Voxalot?

I've tried **.T, *.T, *., etc, with no luck.

Thanks,
The Doc

[emoci]

Originally Posted by doctorh

I have a VTech 8100-2, and plan to use it with Voxalot.

What should be the dial plan (digits) in order to pass everything that is dialed to Voxalot?

I've tried **.T, *.T, *., etc, with no luck.

Thanks,
The Doc

Not familiar with the VTech dial plan, but give this a try:

[*x][*x].T

or if that fails try this (the whole string)

**xx.T|*xx.T|xx.T

[doctorh]

Originally Posted by doctorh

I have a VTech 8100-2, and plan to use it with Voxalot.

What should be the dial plan (digits) in order to pass everything that is dialed to Voxalot?

I've tried **.T, *.T, *., etc, with no luck.

Thanks,
The Doc

Dear Gurues

I'm still fighting this one.

My IP-8100 set uses the same dial plans as all other CYT devices. I cannot find the way to make every dialled call be sent to Voxalot instead of being used as a feature code on the phone. That causes the phone to intercept the *xx numbers, and therefore I cannot use any number at Sipbroker as the dialled number never gets to Voxalot.

This is the digit map I'm using:
[349]11|1xxx[2-9]xxxxxx|[2-9]xxxxxxT|[2-9]xxxxxxxxx|011x.T|*x.T|x.T

But the *x.T is not passing the numbers starting with * to Voxalot.

On my other CPE, a PAP2 v1, I have [x*][x*].+ as the dialing plan, and it works flawlessly, passing everything to Voxalot.

Any clue on how to set a CYT device to pass everything that is dialled to Voxalot?

Thanks so much,

The Doc