ENUM (e164.org) SIPBroker access

carlosalbffgomes · 05-23-2008, 09:18 AM

I've two phone enum numbers registered in e164.org. However, when I dial them the system says that the user I've dialed is currently offline. This is not true, because the number I'm dialing is mine and, when I dial it through SIPBroker alias (*011) or provider alias (*7402) the phone rings. I thing e164.org is taken too much time to resolve the enum number, so SIPBroker returns that the user is currently offline.
Is there a way to solve this? Thanks.

scrag · 06-19-2008, 11:11 AM

I've had this happen too...

I ring a gateway and enter my ENUM and sometimes it returns an engaged signal. The same has happened when I use the Alias *011.

You may be right that it takes too long to resolve and the connection fails.

I also wonder, I'm no expert, if NAT has anything to do with it??

05-23-2008, 09:18 AM	#1
carlosalbffgomes Senior Member Join Date: May 2008 Location: Portugal and Brazil Posts: 107 Thanks: 7 Thanked 26 Times in 21 Posts	ENUM (e164.org) SIPBroker access I've two phone enum numbers registered in e164.org. However, when I dial them the system says that the user I've dialed is currently offline. This is not true, because the number I'm dialing is mine and, when I dial it through SIPBroker alias (011) or provider alias (7402) the phone rings. I thing e164.org is taken too much time to resolve the enum number, so SIPBroker returns that the user is currently offline. Is there a way to solve this? Thanks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Free DID Numbers, Free Voip Calls, & more Voip Info	amroe	Voxalot General	54	01-13-2014 09:11 AM
Unable to access my voip account using sipbroker	anut	SIP Broker Support	6	01-31-2008 05:36 PM
Suggestion: Quick Access to Voicemail via SipBroker	richard	Voxalot Support	0	05-05-2007 02:05 PM
Access SIPBroker via redirected personal DID	kurun	SIP Broker Support	3	02-25-2007 03:40 PM
Clarification on setting up an ENUM with e164.org	silverwing	e164.org Support	4	10-24-2006 10:15 PM

06-19-2008, 11:11 AM	#2
scrag Member Join Date: Oct 2006 Posts: 51 Thanks: 0 Thanked 3 Times in 3 Posts	I've had this happen too... I ring a gateway and enter my ENUM and sometimes it returns an engaged signal. The same has happened when I use the Alias *011. You may be right that it takes too long to resolve and the connection fails. I also wonder, I'm no expert, if NAT has anything to do with it??