|
07-14-2006, 05:10 AM
|
#1 |
|
Junior Member
Join Date: Apr 2006
Posts: 20
Thanks: 0 Thanked 0 Times in 0 Posts  |
SIPME and G711u
Hi,
I just noticed that when using SIPME my codec was G711u -- but I thought that they only used G729a. I am pretty sure that in the past it was using G729a. Does this mean that for my setup voxalot is proxing the session? Is there anyway I can test to see if this is the case? Thanks in anticipation of your advice/comments, Nathan. Last edited by Nathanc; 07-14-2006 at 09:14 AM. |
|
|
|
07-14-2006, 11:53 AM
|
#2 |
  Join Date: Feb 2006
Posts: 2,930
Thanks: 528 Thanked 646 Times in 340 Posts  |
Hi Nathan,
Yes VoXaLot would be transcoding 711 to 729.
__________________
Martin Please post support questions on the forum. Do not send PMs unless requested. |
|
|
|
|
07-14-2006, 03:41 PM
|
#3 | |
|
Member
Join Date: Apr 2006
Location: Chichester, West Suusex, UK
Posts: 80
Thanks: 0 Thanked 0 Times in 0 Posts |
Quote:
|
|
|
|
|
|
07-15-2006, 02:25 AM
|
#4 | |
|
Junior Member
Join Date: Apr 2006
Posts: 20
Thanks: 0 Thanked 0 Times in 0 Posts |
Quote:
Yes, I would like to know the answer to this. I turned off all NAT settings and put the router on DMZ in an attempt to see if I could avoid proxying. I have always had the 'use outbound proxy' turned off also. However, it always seems to do the transcoding / proxying anyway. I am assuming that it is a problem with my end, but I don't think there is any other settings I can turn off or on. Anyway, I have no problems with the service (thanks), everything works fine for me, I was just trying to avoid the proxying. Thanks, Nathan. |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
