View Single Post
Unread 01-29-2007, 02:33 AM   #5
jenalcom
Junior Member
 
Join Date: Jan 2007
Posts: 16
Thanks: 0
Thanked 1 Times in 1 Posts
jenalcom is on a distinguished road
Default

Thanks again for the reply. Much appreciated.

I am at the stage of trying to get the outbound operational!

At this stage I am just playing with one port only and just two providers, Oztell and Mynetfone (trying to keep the variables to as low a number as possible!).

I have successfully called into my Voxalot number from a PSTN gateway and that works fine.

I have both providers set up as Active = "Yes", SIP Registration = "No" for now, and a simple dial plan such that _6. goes out via Oztell and _08. goes out via Mynetfone.

However I don't seem able to make any outgoing calls. All I get is a busy signal (I can use the "600" echo test though so my ATA is ok).

Both VSPs show in the providers list as Active = "Yes", Status = "-". I guess I just have to wait until the status changes to "registered"(?). But will it do that if I have set the SIP registration to NO for both providers. If not should I still be able to make outgoing calls (I understood yes as the answer)?

Thanks again

Alan
jenalcom is offline   Reply With Quote