Quote:
Originally Posted by sprinter
Can NOT reach *600 from ATA, if I change the Symmetric NAT handling to NO (dead air). If I change it back to YES, echo test starts immediately from ATA.
However, if I use EziDial, echo test (or ATA) is reachable...and the NAT handling settings of YES or NO both work!
|
For STUN settings, under NAT Support Parameters, there are two possible setup profiles:
The First:
Handle VIA received: Yes
Handle VIA rport: Yes
Insert VIA received: Yes
Insert VIA rport: Yes
Substitute VIA Addr: No
Send Resp To Src Port: No
STUN Enable: Yes
STUN Test Enable: No
STUN Server: stun.xten.com
EXT IP: (blank)
EXT RTP Port Min: (blank)
NAT Keep Alive Intvl: 20 (or 30)
or
The Second (this is the one I'm using with my PAP2):
Handle VIA received: No
Handle VIA rport: No
Insert VIA received: No
Insert VIA rport: No
Substitute VIA Addr: Yes
Send Resp To Src Port: Yes
STUN Enable: Yes
STUN Test Enable: No
STUN Server: stun.xten.com
EXT IP: (blank)
EXT RTP Port Min: (blank)
NAT Keep Alive Intvl: 20 (or 30)
Setup each profile in turn , and then retry to see if you can get things working with Symmetric NAT disabled:
HowTo: 6 Steps To Optimize Your Audio - Voxalot FAQ
BTW, the port ranges you've opened (you opened both TCP/UDP right? )