Voicemail access using *500 on HT-496
Thanks for that. I have noticed the same problem, and could not find a solution.
I usually listen to the VM on an IP phone which does not have this problem.
I checked the Manual and *50 is the code for Disable call waiting.
The ATA reacts to this immediately without any timeout for further entries or requiring an enter action (#). So then it takes the last part "0#" as a separate entry.
Is it possible for Voxalot to create an access code for Voicemail that does not conflict with the feature list? I believe that there is some standardization in these *xx feature codes, though I have not done too much searching lately.
Thanks
Paul
|