Voxalot / SIP Broker Support Forums - View Single Post

kurun · 02-15-2007, 02:26 PM

Thanks for that. I have noticed the same problem, and could not find a solution.
I usually listen to the VM on an IP phone which does not have this problem.

I checked the Manual and *50 is the code for Disable call waiting.

The ATA reacts to this immediately without any timeout for further entries or requiring an enter action (#). So then it takes the last part "0#" as a separate entry.

Is it possible for Voxalot to create an access code for Voicemail that does not conflict with the feature list? I believe that there is some standardization in these *xx feature codes, though I have not done too much searching lately.

Thanks
Paul

02-15-2007, 02:26 PM	#6
kurun Join Date: Sep 2006 Location: Toronto, Canada Posts: 568 Thanks: 70 Thanked 147 Times in 115 Posts	*Voicemail access using 500 on HT-496** Thanks for that. I have noticed the same problem, and could not find a solution. I usually listen to the VM on an IP phone which does not have this problem. I checked the Manual and 50 is the code for Disable call waiting. The ATA reacts to this immediately without any timeout for further entries or requiring an enter action (#). So then it takes the last part "0#" as a separate entry. Is it possible for Voxalot to create an access code for Voicemail that does not conflict with the feature list? I believe that there is some standardization in these xx feature codes, though I have not done too much searching lately. Thanks Paul