[emoci]

pap2 - line1 to have sipgate(configured) and line2(would like) to have voxalot. Can I then internally forward the line from lin1 to line2 and use just one handset? - It's pap2 and not pap2t. any help on a dialplan would be helpful

For incoming calls to either VoXalot or SIPGate you can try to do one of the following:
-Use the forwarding feature on the PAP2 to forward all you VoXalot call to your SIPGate SIP URI (only if SIPGate accepts icnomin SIP calls)
-Use forwarding feature on PAP2 to forward all incoming SIPGate calls to VoXalot SIP URI (whether SIPGate supports this or not is also not clear)

-There is no way for you to use a single phone for dialing out via both VoXalot and SIPGate, unless you don't mind manually switching the jack from Line 1 to Line 2...

spa3102 - using the dial plan -
- i would like line1 to dial out all 01 and 02 number in the uk through pstn
line1
- dialout 800 number using the voxalot services
+ any other suggestion would be greatly appreciated.

Thanks for your time.

So something along these lines (assuming Line 1 is setup with your VoXalot acct)

(01x.<:@gw0>|02x.<:@gw0>|<*01344:0>8x.|<*:>18[678]x.|[*#x][*x].)

01x.<:@gw0> : When you dial any number 01xxxxxxxxx... it'll go over PSTN (dial # when finished entering number)

02x.<:@gw0> : When you dial any number 02xxxxxxxxx... it'll go over PSTN
(dial # when finished entering number)

<*01344:0>8x. : When you dial 0800xxxxxx... it'll be converted to *013-44-800xxxxx and go over Enum via SipBroker
(dial # when finished entering number)

<*:>18[678]x. : When dialing any 1800|1888|1877 number (US/Canda Toll free) it'll be converted to *1800 and go over SipBroker
(dial # when finished entering number)

[*#x][*x]. : Anything else you may think to dial...will route it over VoXalot