Voxalot / SIP Broker Support Forums - View Single Post - SPA-1001 and PAP2

ataboy · 05-05-2006, 12:51 PM

I have an SPA-1001 that is registered with Voxalot, using dialplan ([x*][x*]. <:@sipbroker.com>|#[x*]. |xx.|) on the ATA.

My providers' list has 4 VSPs and my Voxalot dialplan selects them automatically just as I want. Now I want to set up my PAP2 to do the same. I have set it up in an identical manner - same settings, same dialplan. However, the dialtone that it delivers starts with a fast busy-type tone. This is followed by a short burst of dialtone, then it drops out.

I have both ATAs running on the same LAN. I considered that this might cause a clash, so I disabled the SPA-1001 but it made no difference.

Does anybody have any ideas why this won't work?

ataboy

05-05-2006, 12:51 PM	#1
ataboy Senior Member Join Date: May 2006 Location: Greater London, UK Posts: 198 Thanks: 36 Thanked 23 Times in 23 Posts	SPA-1001 and PAP2 I have an SPA-1001 that is registered with Voxalot, using dialplan ([x][x]. <:@sipbroker.com>\|#[x*]. \|xx.\|) on the ATA. My providers' list has 4 VSPs and my Voxalot dialplan selects them automatically just as I want. Now I want to set up my PAP2 to do the same. I have set it up in an identical manner - same settings, same dialplan. However, the dialtone that it delivers starts with a fast busy-type tone. This is followed by a short burst of dialtone, then it drops out. I have both ATAs running on the same LAN. I considered that this might cause a clash, so I disabled the SPA-1001 but it made no difference. Does anybody have any ideas why this won't work? ataboy