Quote:
Originally Posted by boatman
I have a Linksys SPA2100 and am trying to get the attached phone to chirp every 300 seconds to indicate that I have a Voxalot VM waiting. Currently I do have a new VM at Voxalot, my phone chirped a few minutes after the VM arrived, and in my ATA under User_1 tab I see
Message Waiting: yes
Prior to the VM arriving I set the following:
VMWI Refresh Intvl: 300
VMWI Ring Splash Len: .5
VMWI Ring Policy: New VM Available
I also made sure that these are set as follows:
MWI Serv: yes
VMWI Serv: yes
Seem like my phone should now be chirping a .5 second ring every 5 minutes, but it's not. All I get is the stutter dial tone.
Did I miss something?
Has anyone actually got a Linksys ATA to chirp at intervals to indicate unread Voxalot VM? It would be great to have this work, as I would no longer have to pick up the phone and check the dial tone to know if I have VM waiting.
Thanks!
|
I noticed this seemed to start working on my PAP2 if I also turned on:
Ring on New VM
I also had VMWI Ring Splash Len: 1
I did not test long enough to determine how consistent it was (not a big fan of the phone chirping every 5 minutes)