Voxalot / SIP Broker Support Forums - View Single Post - Dialing SipBroker / Voxalot * Numbers on Sipura

richard · 09-10-2007, 12:53 PM

Hi emoci

Thanks, your suggestion works good ;-)

There is only one issue. One the SPA-1001, currently "#" is set to toggle between lines, so the use of "#" conflicts with the Virtual line toggle.

I was also wondering if there is a way to tell the SPA to send all * commands to Voxalot and simply ignore its Internal Vertical Services Activation Codes or just selected ones.

For instance I will like to reprogram *98 to send me to Voxalot *500, so that the experience is the same as my PSTN Line which uses *98 for voicemail.

thanks again

Richard

PS > On my SPA3000 I do not have the conflict with the use of * codes. I think it might be because of the use of gateways, but I haven't fully investigated yet.

09-10-2007, 12:53 PM	#3
richard Senior Member Join Date: Mar 2006 Posts: 153 Thanks: 37 Thanked 7 Times in 7 Posts	Hi emoci Thanks, your suggestion works good ;-) There is only one issue. One the SPA-1001, currently "#" is set to toggle between lines, so the use of "#" conflicts with the Virtual line toggle. I was also wondering if there is a way to tell the SPA to send all * commands to Voxalot and simply ignore its Internal Vertical Services Activation Codes or just selected ones. For instance I will like to reprogram 98 to send me to Voxalot 500, so that the experience is the same as my PSTN Line which uses 98 for voicemail. thanks again Richard PS > On my SPA3000 I do not have the conflict with the use of codes. I think it might be because of the use of gateways, but I haven't fully investigated yet.