pap2v2 - voxalot. able to dial 1800-xx no incoming
 

I registered a unloacked pap2v2 to voxalot.
Funny thing is when I try *500 or *600 I get busy signal tone.
But I am able to dial 1800 numbers which means my ATA is registred.

If I usde PSTN to voxalot dial. I dont get the incoming call

Any thoughts?

Is there any way I could run some debugger to see what is happening?

configuration

username - 811011
proxy - us.voxalot.com
SIP port 5060
regustrar - us.voxalot.com

I think your ata is blocking the *. You must explicitly allow it in the dial plan.

To allow *500 and *600, I use |*[56]00S0|

Try following ctylor's sticky on how to set up sipura/linksys devices in this forum.
Consider using the recommended dial plans in the tutorial.
It is very easy to follow and I was up and running the first time I tried.

FIrst of all ctylor Big Thanks.
I heeded to everyone's advice.

Still have issue
Below is my settings.

Dialplan
(*[56]00S0 |*xxx[x*]. |x |*xx |1[89]76x.! |1[79]00x.! |1[2-9]xx[2-9]xxxxxxS0 |#x1[2-9]xx[2-9]xxxxxxS0 |011xx. |411S0 |<:1212>[2-9]xxxxxxS0 |#x<:1925>[2-9]xxxxxxS0 )

user 811011
pwd = my pwd
Proxy server = us.voxalot.com
registrar address = us.voxalot.com Also tried with IP 64.34.173.199
proxy port 5061
registrar port 5060

No success yet

Why 5061, Voxalot does not listen on this port. Try changing this to 5060.

I tried mov ing voxalot to LIne 1 and port 5060. Is anyone using a pap2v2 with voxalot?

Try doing a search on the forum there a lots of posts with people using this device.