Busy Signal
 

I get a busy signal when calling any #. When I look at the logs, voxalot shows calls failed. But when I test a # through the setup page, it appears to be successful. Receives calls just fine. Any ideas? Thanks.

What device or softphone are you using.....?

Chances are you need to adjust your ATAs dial plan line, such that it passes all calls to VoXalot as you dial them and let VoXalot deal with modification and routing....

If you can post what your ATA's dialplan currently looks like, we can probably offer some pointers...

Ok. I'm using a D-Link DVG-1402S. There doesn't appear to be a way to set a dial-plan string anywhere in the config pages, unless I'm just not seeing it. The only dial plan I have setup is the one in Voxalot, and it's the default. Voxalot is setup to use voipvoip as my vsp. I've got STUN in use and it shows the mapped ports. Some setup parameters follow.

Server FQDN enabled
IP Address . . .
Domain Name voxalot.com
Port 5060
Service Domain us.voxalot.com
URL Format SIP-URL
User Parameter Phone enabled
Caller ID Delivery YES
Display CID enabled
Timer T2 sec

Initial Unregister enabled
Register Expiration 3600 sec
Session Expires 180 sec
Min-SE 180 sec
Session Expires Refresher uac

Outbound Proxy enabled
Outbound Proxy FQDN enabled
Outbound Proxy IP . . .
Outbound Proxy FQDN Domain us.voxalot.com
Outbound Proxy Port 5060

Codec Priority & Packet Interval
G.711a-law 20 ms
G.711u-law 20 ms
G.723.1 20 ms
G.729a 20 ms
G.726 20 ms

Still no ideas? Anything else to try? I've tried it with the firewall off, port forwarding, different vsp's. What else should I try?