MWI Update Interval

[richard]

Hi Everyone

Right now I'm getting the MWI when a Voicemail message is left in my Voxalot VM, but there is a 3 to 5 minute delay before the MWI comes on and a 3 to 5 minute wait after the message is clear.

Is there a way to control this interval in my Hard/Softphone settings?

Thanks in advance

Richard

[DracoFelis]

Originally Posted by richard

Is there a way to control this interval in my Hard/Softphone settings?

Depends upon the Hard/Softphone you are using. For example, on LinkSys/Sipura adapters, the setting you want to play with is the "VMWI Refresh Intvl:" setting (on the "Regional" tab).

The proper setting (if any) on other adapters (and all softphones) is left as an exercise to the student.

[richard]

Hi DracoFelis

On my Sipura Adapters, the VMWI Refresh Intvl is set to "0"

If this means that it "Never" refreshes, I'm just wondering why it does update the status every 3 to 5 minutes?

Any recommended level, 30 seconds, 60 seconds? I'm assuming the value is in seconds.

Thanks for your help.

Richard

[martin]

Originally Posted by richard

Any recommended level, 30 seconds, 60 seconds? I'm assuming the value is in seconds.

Thanks for your help.

Richard

Due to volumes Voxalot batches them up into 5min intervals.
.

[richard]

Hi Martin

Thanks for the update. Quite understandable.

Should I leave the internval at 0 or 30 seconds or does it not really matter? Both 0 and 30 seems to take the same amount of time to update.

Richard

Originally Posted by martin

Due to volumes Voxalot batches them up into 5min intervals.
.

[martin]

Originally Posted by richard

Hi Martin

Thanks for the update. Quite understandable.

Should I leave the internval at 0 or 30 seconds or does it not really matter? Both 0 and 30 seems to take the same amount of time to update.

Richard

Hi Richard,

It wont make any difference as the servers control the interval.
.

[DracoFelis]

Originally Posted by richard

Should I leave the internval at 0 or 30 seconds or does it not really matter? Both 0 and 30 seems to take the same amount of time to update.

On LinkSys/Sipura adapters, "VMWI Refresh Intvl:" of zero means to never "refresh" the signal to your phones. i.e. send the signal from the adapter (to your phones) when the state changes (in the adapter), and hope your phones get the signal that first time. But if (for any reason) the phones miss that command, your phones will be "stuck" in the wrong state until the adapter state again changes.

For any non-zero value of "VMWI Refresh Intvl:", LinkSys/Sipura adapters will send the current state of the VM to your phones every X seconds. Set it to whatever you like (I have mine set to 300). By setting a non-zero value, the phones in your house never risk getting their VM light "stuck" in the wrong state, as the adapter will "refresh" the state info every X seconds.

However, if/when you use a non-zero "VMWI Refresh Intvl:" setting, be sure to also use "VMWI Ring Splash Len: 0" (on the "Line x" tab), or you might end up with your phone chirping every X seconds, like clock work.