Well I won't mess with my settings then, here they are (mostly from the FAQ btw):
VOXALOT:
Using inbound1 (active, registered)
Using outbound1 (active, not registered)
Symmetric NAT = no
VITELITY:
Under subaccount I've got NAT enabled
For the DID Routing...Protocol = SIP...Type = ATA Device, IP Phone or Softphone...Account = Selected my proper subaccount (what I use in Voxalot to register)
If I had the Type set as PBX Server, then inbound calls would just give me a busy signal (NOANSWER according to Vitelity). Outbound calls would work fine though. If I unregistered Vitelity in Voxalot settings, then inbound calls would also give a busy signal (CHANUNAVAIL according to Vitelity, which is a not-registered error).
Only thing I wish? East Coast Vitelity servers, a few milliseconds never hurt.
|