Hi dc2007
Not quite sure what you are getting at here:
Quote:
Originally Posted by dc2007
try to put a number in PSTN Caller ID Pattern:
leaving it blank makes pstn caller goes directly to your Default DP
but putting number there restricts the rest of the callers to use your voip gateway and that somehow prevents erroneous use of your voip account unless you add their number in that caller id pattern section.
|
From reading a number of thread here and on the Whirlpool forums, I understand that there are 2 ways of getting PSTN to divert to VM using the SPA-3102:
- Use CFwd parameters on the Line 1 and User 1 tabs to route the call
- Use the PSTN-to-VoIP gateway
I have been unable to divert to VM using the CFwd method so far.
Using the PSTN-to-VoIP gateway method, I have the following settings on the PSTN Tab (along with my understanding of how they work):
PSTN Caller Auth Method = None (don't authenticate)
PSTN Caller ID Pattern = Blank (any number sequence is valid)
PSTN Access List = Blank (all numbers have access to VoIP Gateway)
PSTN Caller Default DP = 4 (if no PIN match, this is the default)
Dialplan 4: (S0<:xxxxxx@au.voxalot.com>)
I can see on the info tab during a PSTN call, that the call is being forwarded to the address in dialplan 4 and since this is the behaviour I wanted, I am sure those settings are OK.
What I am not clear about is whether you think that using CFwd on the Line 1 tab requires different settings in the above fields?
Cheers