View Single Post
Unread 09-15-2007, 03:46 AM   #17
martin
 
Join Date: Feb 2006
Posts: 2,930
Thanks: 528
Thanked 646 Times in 340 Posts
martin is a jewel in the roughmartin is a jewel in the roughmartin is a jewel in the roughmartin is a jewel in the roughmartin is a jewel in the roughmartin is a jewel in the rough
Default

Quote:
Originally Posted by richard View Post
Martin

Is there a specific change or tweak I can make to my Dad's SPA-1001 to enable re-invite. I'm not sure which of those setting that have the words "re-invite" in it I need to change.

Any help would be appreciated.

Richard
To my knowledge there are no specific settings. The trick to resolve the NAT issues.

Here are some recommended settings:

Code:
Setup your adapter for use behind a NAT router

    * Setup STUN on your adapter (NOTE: STUN settings are on the SIP tab)
          o Handle VIA received: no
          o Handle VIA rport: no
          o Insert VIA received: no
          o Insert VIA rport: no
          o Substitute VIA Addr: yes
          o Send Resp To Src Port: yes
          o STUN Enable: yes
          o STUN Test Enable: no
          o STUN Server: stun.voxalot.com:3478
                + NOTE: You can replace the above STUN server with any STUN server you like... 
          o EXT IP:
                + NOTE: Leave this setting blank, STUN will figure this out for you... 
          o EXT RTP Port Min:
                + NOTE: Normally you can leave this blank, but you can set this if you have a specific need 
          o NAT Keep Alive Intvl: 45
                + NOTE: Use an value SHORTER than the "timeout" value in your router. 
    * set "NAT Mapping Enable: yes"
Also check the "Symmetric NAT" setting on the member details page within Voxalot.
.
__________________
Martin

Please post support questions on the forum. Do not send PMs unless requested.
martin is offline   Reply With Quote
The Following User Says Thank You to martin For This Useful Post:
richard (09-15-2007)