Quote:
Originally Posted by richard
Martin
Is there a specific change or tweak I can make to my Dad's SPA-1001 to enable re-invite. I'm not sure which of those setting that have the words "re-invite" in it I need to change.
Any help would be appreciated.
Richard
|
To my knowledge there are no specific settings. The trick to resolve the NAT issues.
Here are some recommended settings:
Code:
Setup your adapter for use behind a NAT router
* Setup STUN on your adapter (NOTE: STUN settings are on the SIP tab)
o Handle VIA received: no
o Handle VIA rport: no
o Insert VIA received: no
o Insert VIA rport: no
o Substitute VIA Addr: yes
o Send Resp To Src Port: yes
o STUN Enable: yes
o STUN Test Enable: no
o STUN Server: stun.voxalot.com:3478
+ NOTE: You can replace the above STUN server with any STUN server you like...
o EXT IP:
+ NOTE: Leave this setting blank, STUN will figure this out for you...
o EXT RTP Port Min:
+ NOTE: Normally you can leave this blank, but you can set this if you have a specific need
o NAT Keep Alive Intvl: 45
+ NOTE: Use an value SHORTER than the "timeout" value in your router.
* set "NAT Mapping Enable: yes"
Also check the "Symmetric NAT" setting on the member details page within Voxalot.
.