VoXaLot has developed a workaround for the NAT issues surrounding the Nokia eSeries phone. If you are interested try these settings:
SIP Settings:
Profile name: VoXaLot
Service profile: IETF
Default access point: <for you to define>
Public user name: sip:xxxxxx@us.voxalot.com <- where xxxxxx is user VoXaLot user name. If you want to use the Australian cluster set to
sip:xxxxxx@au.voxalot.com and for Europe set
sip:xxxxxx@eu.voxalot.com
Use compression: No
Registration: Always on
Use security: No
Proxy server:
Proxy server address: sip:us.voxalot.com <- If you want to use the Australian cluster set to
sip:au.voxalot.com and for Europe set
sip:eu.voxalot.com
Note: Older version of firmware require IP addresses. If that is the case use:
Proxy server address: sip:64.34.163.35 <- For the Australian cluster use
sip:202.60.75.46 and for Europe use
sip:85.17.19.194
Realm: voxalot.com
User name: xxxxxx. <- where xxxxxx is user VoXaLot user name
Password: <your VoXaLot password>
Allow loose routing: Yes
Transport type: UDP
Port: 5060
Registrar server:
Registrar server address: sip:us.voxalot.com <- If you want to use the Australian cluster set to
sip:au.voxalot.com and for Europe set
sip:eu.voxalot.com
Realm: voxalot.com
User name: xxxxxx. <- where xxxxxx is user VoXaLot user name
Password: <your VoXaLot password>
Allow loose routing: Yes
Transport type: UDP
Port: 5060
Once the eSeries is registered, to test inbounds from any other phone dial any of the SIP Broker access numbers found here:
http://www.sipbroker.com/sipbroker/action/pstnNumbers
At the voice prompt, dial *010xxxxxx <- where xxxxxx is user VoXaLot user name
Your eSeries should ring.