Quote:
Originally Posted by Hellmaker
mhhh my viop client just supports all the G.723.1, G.729a, G.711u, G.711a, G.726 codecs.........
i think it is using the g729 then?
is there any way to configure it to use the ulaw/alaw ones? or must it be supported by my voip client?
|
Codec setup is always in 2 parts:
1. Between VoIP client and voxalot the setup is done at the client. So if you want to restrict codecs between the VoIP client and voxalot you must do so in the client itself.
2. Between voxalot and the provider the setup is done on the provider details page. If you want to restrict codecs between voxalot and the provider then you must edit the Codecs value on this page.
Note: If you want to avoid transcoding then make sure that the codecs defined in both 1 & 2 are the same.