Quote:
Originally Posted by than30fyl
Dear emoci,
Thanks for all the info.
I've purchased a Linksys/Sipura SPA3102 to replace my fritz.box 7140. I have one provider registed with Line1 and Voxalot as my Gateway1. The ports used are 2060. Everything is working as expected, except for the disconnect after 20 seconds, that voxalot connections - suffer.
I've setup the STUN: stun.xten.com, and NAT keep alive on my accounts. Also i have forward ports:
2060 UDP and (RTP) 16384-16482 UDP to my SPA3102 adapter.
I've also followed the aritcle metioned in the previous reply.
Still Voxalot will disconnect after exactly 20 seconds.
Any ideas please?
~thanasis
|
-Open and forward the following ports to the ATA:
5050-5064 Both TCP/UDP
5000-5005 Both TCP/UDP
16300-16500 Both TCP/UDP
2060 Both TCP/UDP
-Under 'NAT Support Parameters heading' try these:
Handle VIA received: Yes
Handle VIA rport: Yes
Insert VIA received: Yes
Insert VIA rport: Yes
Substitute VIA Addr: No
Send Resp To Src Port: No
STUN Enable: Yes
STUN Test Enable: No
STUN Server: stun.xten.com
EXT IP: (blank)
EXT RTP Port Min: (blank)
NAT Keep Alive Intvl: 20 (or 30)
or
Handle VIA received: No
Handle VIA rport: No
Insert VIA received: No
Insert VIA rport: No
Substitute VIA Addr: Yes
Send Resp To Src Port: Yes
STUN Enable: Yes
STUN Test Enable: No
STUN Server: stun.xten.com
EXT IP: (blank)
EXT RTP Port Min: (blank)
NAT Keep Alive Intvl: 20 (or 30)
-Also in your VoXalot acct. try the following combinations:
NAT Symmetric Handling: NO
Optimize Audio: Yes
or
NAT Symmetric Handling: NO
Optimize Audio: NO
or
NAT Symmetric Handling: Yes
Optimize Audio: NO
-Make sure that 'NAT Keep Alive', and 'NAT Mapping Enable' are both set to Yes in the SPA