Thanks again for the reply. Much appreciated.
I am at the stage of trying to get the outbound operational!
At this stage I am just playing with one port only and just two providers, Oztell and Mynetfone (trying to keep the variables to as low a number as possible!).
I have successfully called into my Voxalot number from a PSTN gateway and that works fine.
I have both providers set up as Active = "Yes", SIP Registration = "No" for now, and a simple dial plan such that _6. goes out via Oztell and _08. goes out via Mynetfone.
However I don't seem able to make any outgoing calls. All I get is a busy signal (I can use the "600" echo test though so my ATA is ok).
Both VSPs show in the providers list as Active = "Yes", Status = "-". I guess I just have to wait until the status changes to "registered"(?). But will it do that if I have set the SIP registration to NO for both providers. If not should I still be able to make outgoing calls (I understood yes as the answer)?
Thanks again
Alan
|