Quote:
|
Originally Posted by Mallycat
I have gone to http://www.canyouseeme.org/ to test if I can see 5060, and it says that this port can't be seen. I have tried everything I can think of to make it visible, but can't get it exposed. I have port forwarded, dmz but nothing. I have switched off all other firewalls on my PC to try to get it exposed but nothing. Any Ideas? |
The test results you're getting from this site may be misleading. I have no problems receiving calls directly into any of ports on the three PAP2's I currently have online, yet this site reports:
Error: I could not see your service on xxx.xxx.xxx.xxx on port (5060)
Reason: Connection refused
SIP uses UDP to transport packets, so I assume most SIP devices refuse TCP connections.
What router and what firmware are you using in it? UDP port forwarding through NAT is not supported correctly in a lot of routers.
A full description of your configuration would be helpful (what ATA are you using, what port forwarding entries do you have set, etc.).
Ron