Hmm. Still have the same problems, dialing *393613, the call initiates OK, but after about 3 seconds it goes silent and then hangs up.

But, if I dial through sipme, there is no problem. For you info -- in case it's my setup --, I have setup a dial plan in voxalot to send numbers directly to sipme (ie. I dial #3*393613 -- #3 tells it to go to sipme).

I use the FWD stun (stun.fwdnet.net).

My wireless router handles NAT (Dlink DI-624+), I forward some ports in the 'virtual server' (5060/1) for the ATA, but other than that I have no special settings except to enable the NAT Keep Alive on the PAP2.

It's funny, because I don't think I have had this problem before -- I have used the echo test several times without any problems. And, it works via sipme. It's not a big issue, but I'll keep trying on my end to see if I can fix it, unfortunately I don't know anyone on FWD to test call (other than echo).

Are there any other specific NAT settings that may help figure out what's wrong?

Cheers,
Nathan.

i too still have the Pennytel issue. I just called from my house phone to my mobile and as Nathan has reported, a buzzing noise on my mobile and silence on my house phone :S

i have not yet tried .com, but just thought i would let you know Martin.

btw, to answer your question, yea it does appear that the issue is only occuring with Pennytel as Koala works completely fine out voxalot.com.au

thanks for looking into this for us.

I tried using webcallback to call my voxalot number and the echo test (via SIPBroker), then echo test works when I do this, but it still goes silent after 3 seconds if I simply dial *393613.

Nathan.

Hi,

The Belgiums also noticed problems with their DIDs going to FWD:

http://forum.sipbroker.com/showthrea...=2210#post2210

What happens when you dial *266300 instead?

Seems to work fine, I get the monkeys singing away.

Thanks,
Nathan.

Your problem is more than likely Codec then. While the monkies are playing check what Codec is being used.

Compare that against FWD. Last time I checked they only supportted g711

Hi Again,

Checked the codec - it is g711u

via SIPME -- works

via webcallback-SIPBroker -- works

but not when I simply dial *393613

For all these three methods, the call settings that come up on the PAP2 are similar.

Do you think it's at my end? I'm not particularly worried about it, but I am curious as to why this is happening.

Thanks for the suggestions,
Nathan.

Hi Martin, is there any testing you want me to do? As I am still unable to make Pennytel calls through voxalot :(

Let me know if there is anything I can do to help.