Inbound calls problem
Voxalot, please fix the issue.
I have had this problem for two days. Three Linksys 3102 devices located in different places and registered to three different Voxalot accounts have the same problem: all inbound calls which are set up to go to My Voxalot Number end up in the voicemail. You must have changed something on your side since I changed nothing lately. Please have a look into that. Thanks |
I noticed that calling between Voxalot accounts takes extremely long, in my case they need at least 20 seconds to reach each other. And when they do, the voicemail picks up, regardless of the CF settings.
|
Quote:
|
Quote:
All of them are registered with us.voxalot.com |
Maybe you configured each ATA to all use the same STUN server and that server is down, and that's how they're all down at once.
Other servers are listed here: STUN - voip-info.org |
Quote:
Voxalot must have changed something lately, it has to do with how calls are being treated while set to go to My Voxalot number. |
Quote:
There are two methods for maintaining a NAT route through the router to the SPA3102, needed so the SPA3102 can receive calls. The methods are port forwarding, or sending NAT-keep-alive packets. Which method do you use in your routers? If you are using port forwarding I can check that your SPA3102 units are reachable. Just send me the public IP address, 'User ID' and 'SIP Port' of the lines to be tested. I can do the test without ringing your phone, or I can make a SIP call and check the SDP packet at the same time. |
Quote:
These SPA3102 have worked fine for many months without any incidents. Something have changed lately but I did not change anything. Would stun.xten.com be faulty all of a sudden ? I will have to test... |
Quote:
Sometimes its preferable to operate the ATA independently of a stun server. The benefit is that phone service can continue no matter if the stun server is working. To do that see steps 1 to 4 below. 1. Forward the SIP ports and the RTP port range from the router to the ATA. 2. Set "STUN Enable:" no 3. Set "NAT Keep Alive Enable:" no 4. The ATA must learn it's public IP address, either through normal SIP registration, or place your public IP address in the 'EXT IP:' field). I understand that you have not configured port forwarding in the routers, and that's OK. My question now is; are any of those SPA3102 units able to receive a call within the first 60 seconds after SIP registration to the Voxalot proxy? |
Quote:
If I call from a different Voxalot account, it reaches the device after at least 15 seconds (whereas it used to be instant until last Saturday). But instead of getting to the VOIP-to-PSTN Gateway as it has always done, it keeps ringing until the voicemail picks up. Two of those SPA 3102 that are registered with two different accounts, with different IP, started behaving weirdly on the same day without my intervention. |
All times are GMT. The time now is 02:33 AM. |
Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.