Voxalot / SIP Broker Support Forums

Voxalot / SIP Broker Support Forums (http://forum.sipbroker.com/index.php)
-   Voxalot Support (http://forum.sipbroker.com/forumdisplay.php?f=4)
-   -   Problem: stun.voxalot.com (http://forum.sipbroker.com/showthread.php?t=4055)

pday 05-26-2009 03:48 PM

Problem: stun.voxalot.com
 
It seems stun,voxalot.com is broken. As can be seen below, I'm on an open internet connection but I still can't get to stun.voxalot.com.

patrick@Sputnik2:~$ stun numb.viagenie.ca
STUN client version 0.96
Primary: Open
Return value is 0x000001
patrick@Sputnik2:~$ stun stun.voxalot.com
STUN client version 0.96
Primary: Blocked or could not reach STUN server
Return value is 0x00001c

carlosalbffgomes 05-26-2009 09:16 PM

Me too!
+----------------------------------------------------------------------------+
cagomes@cagomes-laptop:~$ stun stun.voxalot.com
STUN client version 0.96
Primary: Blocked or could not reach STUN server
Return value is 0x00001c
+----------------------------------------------------------------------------+
cagomes@cagomes-laptop:~$ stun stunserver.org
STUN client version 0.96
Primary: Independent Mapping, Port Dependent Filter, preserves ports, no hairpin
Return value is 0x000017
+----------------------------------------------------------------------------+

martin 05-27-2009 11:03 AM

This problem should now be resolved. Please let use know if it is still a problem?

carlosalbffgomes 05-27-2009 12:45 PM

Fixed!
 
It's fixed. Thanks.

cagomes@cagomes-laptop:~$ stun stun.voxalot.com
STUN client version 0.96
Primary: Indepndent Mapping, Port Dependent Filter, preserves ports, no hairpin
Return value is 0x000017

boatman 05-27-2009 06:47 PM

Sometimes it's possible configure a SIP device (behind a NAT router) to work without stun. This allows phone service to continue no matter if the stun server is working. These instructions are for a Linksys ATA but also work for some other SIP hardware and software.

1. In the router, forward the SIP ports and the RTP port range to the ATA.
2. Set "STUN Enable:" no
3. Set "NAT Keep Alive Enable:" no
4. In order for the ATA to know it's public IP address, make sure the ATA is registered with at least one SIP registrar, or enter your public IP address into the appropriate setting in the ATA (in Linksys ATAs this setting is "EXT IP:").


All times are GMT. The time now is 11:58 PM.

Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.