Callcentric and sipbroker in dial plan
 

It would appear, from my experiments, that callcentric does not support putting <:@sipbroker.com> in the dial plan as suggested in the sipbroker wiki. Can any one verify that this is correct -- Callcentric does *not* support this form of peering? Thank you.

Not clear as to which dial plan you are referring to, or which entry in the Sipbroker wiki.
However if you are referring to the Voxalot dial plan, it does appear that you are correct.

In the Voxalot dial plan, you can enter the first part of the sip address (part before the "@" symbol) as a replacement entry, and send it via the default provider "Sipbroker".

Thanks. I was referring to this entry: SIP Broker Wiki : SIP Broker Wiki .

Are you saying that this technique works only if your VOIP provider is Voxalot? I was trying it on Callcentric to no avail, even though they support manual peering.

If this dialplan does not work outside Voxalot, the Wiki should be revised to say that, no?

Well, you don't need to, Callcentric allows you to make (Sipbroker) P2P calls,
with **275
Callcentric FAQ - Features
also sip-uri's are allowed in speeddials

btw. you should ask your question at Callcentric, but they also have a good FAQ

The dial plan you are referring to is for specific Sipura or Linksys and is not required by most generic ATA adapters.

Just set up dial plans in Voxalot on-line in your account, and that should be all you need, unless you are using the Linksys type ATA.